Users are first provided with the design information about the part or assembly and its design intent. Then, they see an overview of steps involved in modeling the part/assembly. This is accompanied by detailed instructions showing goals, steps and commands in a four column presentation. The consistent approach is supplemented by many illustrations on each page. Each chapter adds new information while reinforcing key concepts. The focus of the text is on teaching actual design modeling using Pro|ENGINEER rather than teaching a set of commands. The book illustrates the part, drawing and assembly creation with several industrial examples. These parts fit together in the final chapters to form one large assembly. Table of Contents 1. Introduction 2. Bearing 3. Bearings 4. Bushing 5. Retaining Ring 6. Nuts and Bolts 7. Shaft 8. Shaft Drawing 9. Radial Plate Cam 10. Housing 11. Cam Assembly 12. Cam Follower Assembly 13. Washington Monument and Wing 14. Gateway Arch 15. Springs 16. Spur and Helical Gears 17. Axial Cam 18. Grooved Cam 19. Bolt Heads 20. Electrical Fuse Assembly

Hide more